Description: With SD and MMC memory prices dropping, the time is right for mass storage and datalogging. This breakout board will allow you to breakout the SD/MMC socket to a standard .1"11-pin header. Perfect for breadboarding and the likes. Board comes fully assembled and tested as shown.
This is the new Push-Push type socket. The board has 11 pins:
COM : Common - Connects to the housing
WP : Write Protect Detect Switch
CD : Card Detect Switch
P9 : Not used in SPI Mode (Pin 9 on SD Card)
IRQ : Not used in SPI mode (Pin 8 on SD Card)
DO : Serial Data Out
GND : Ground - Connect this to COM to ground the housing
CLK : Serial Clock
VCC : 3.3V Power
DI : Serial Data In
CS : Chip Select
It is recommended that you connect the COM pin to GND if you plan to use the CD or WP pins.
Dimensions: 1.3x1.5"
Documents:
Schematic
Eagle Files
Simplified SD Specification
Maxim App Note using the MAXQ2000
App note from Kronos Robotics
Replaces: BOB-00204
DIGITAL JUICE
No comments:
Post a Comment
Thank's!